Sundance® Spas Flow Switch

Part Numbers: 6560-857, Q-12DS-C2

Details:

• Flow Switch with Transparent Tee Fitting
• 3/4" Barbed
  • Note: if your flow switch has a barb fitting (3/8") off the bottom of the Tee then you need to order the 6560-860 Flow Switch

Used On the Following Spa Models:

• All 1-Pump Sundance® Spas using the 6500-301 or the 6500-310 Heater
• Except for 2001+ Capri

Flow Switch with Transparent Tee Fitting. Fits All 6/99 - Present 1 Pump Sundance Systems (Except 2001+ Capri). 3/4" Barbed
A defective flow switch will cause a "Flashing Flo" or even a "Solid Flo" on the Control Panel Icon. "Solid Flo" is the Flo Switch, a "Flashing Flo" could be: Flo Switch, Circulation Pump(clogged or defective), Dirty Filter.
The connectors on the Flow Switch are attached to a pc board connector that is located on the PC Board (usually at the top). There are other wires connected to this plug: Jumper interlock wire,Flow Switch, High Limit and Temp sensor. Remove the pin connector from the board . To remove a sensor or switch wire from the sensor harness connector, insert a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine, allowing the wire to be pulled from the harness connector. Important! When reinstalling the sensor or switch wire back into the sensor harness connector, make sure the pin tine is lifted (approx. 1/32" prior to inserting the wire. This will insure the sensor wire locks into the harness connector. Do not over bend the pin tine or it may break off.