Spa Pump for Sundance® Spas Telluride

6500-138, 6500-268, 6500-768, 6500-355

For spa models that use this pump see the "Applications" tab above.

Specifications

• 240 Volt
• 2 Speed
• 12.0/3.3 Amp
• 4.2 Brake HP, 2.5 HP continuous duty wetend
• 48 Frame

New Motor with Sundance/Jacuzzi Piranaha Wet End

The new version pump replaced Emerson (US) Motor. The only difference in the Factory Pump and ours is that ours comes with the original welded bracket on the motor instead of the bracket mount currently used by Sundance. Ours replaces the original welded on bracket found in your spa.

This can be used for other Sundance pumps by adjusting the position of the wet end. Simply loose the rear 4 bolts (this is a thru bolt motor) and turn the wet end to the position of the original pump then retightening the 4 bolts. We send the pump in the 6500-268 position which is the 12:00 position.

We only use a Viton Seal in our wet ends for long life. The viton seal is designed for harsh chemical environments such as salt, ozone and chemically treated water. Because of their better durability these seals are more costly than a standard seal used by most of our competitors.

Has the welded foot pedestal on the motor itself. Does not come with power cord.

Wiring Diagrams

Please Note We include the wiring diagram for your motor which is also on the ID plate of the Motor. The Motors are 240 Volts with 4 wires: Red (High Speed), Black (Low Speed), White (240Volt Common) and Green (Ground). Please note the manufacture of your motor and select the correct wiring diagram. It may vary from your original wiring on your original spa motor.

Single Speed Use: This 2 speed pump is used as the primary pump but can be used as a single speed. If you need it to run as a single speed, then you would would not hook up the low speed wires. Hook up the Black (High Speed) and the White (240Volt Common).