SundanceŽ, Sweetwater, and JacuzziŽ Spas Flow SwitchPart Numbers: 2560-040, Q12DS-C2 Details:- Flow switch with clear tee fitting
- Cable has Curled Finger Connectors. Do not use on other models!
- Part number on Flow Switch:Q12DS-C2
- Flow Switch now comes molded with a 3/32 inch hole opening. Prior to February 2008 a 3/32" hole had to be drilled for it to be installed on all 2002-2008 2 and 3 pump models.
Used On the Following SundanceŽ Spa Models:- 10/2016+ 980 Series: Kingston, Claremont
- 2016+ 880 Series: Maxxus, Aspen, Optima, Cameo, Altamar, Marin, Capri
- 2013-03/2017 780 Montclair
- 2011+ Select Series: Constance, Victoria
- 2008-03/2017 780 Series: Camden, Certa, Chelsee, Hamilton, Hamilton (w/circ pump) Hartford, (w/circ pump), Burlington (w/circ pump)
- 2007-2012 680 Hartford, Hawthorne Models equipped with a Circ Pump
- 2007 Hamilton, Chelsee, Certa, and Camden
- 2005-2006, 780 Palermo, Bahia, and Cayman
- 2003-2004 Sweetwater Models: Palermo Bahia, Cayman
Used On the Following JacuzziŽ Spa Models:- 2002-2003 J-320, J-330, and J-340 Models
- 2004+ J-335,J-345
- 2007+ J-355,J-365, J-375 Models
- 2007+ J-230, J-270, and J-280 Models with the Circulation Pump Option
- J-300 LED Series (With Curled Finger Connectors)
- 2007+ J-280, J-270, J-230 With optional Circulation Pump
- 2002-2003 J-320, J-330, J-340
- 2007+ J-355, J-356, J-375
- 2011+ JLX, JLXL models
DO NOT MISTAKE FOR 6560-860
A defective flow switch will cause a "Flashing Flo" or even a "Solid Flo" on the Control Panel Icon. "Solid Flo" is the Flo Switch, a "Flashing Flo" could be: Flo Switch, Circulation Pump(clogged or defective), Dirty Filter.
The connectors on the Flow Switch are attached to a pc board connector that is located on the PC Board (usually at the top). There are other wires connected to this plug: Jumper interlock wire,Flow Switch, High Limit and Temp sensor. Remove the pin connector from the board . To remove a sensor or switch wire from the sensor harness connector, insert a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine, allowing the wire to be pulled from the harness connector. Important! When reinstalling the sensor or switch wire back into the sensor harness connector, make sure the pin tine is lifted (approx. 1/32" prior to inserting the wire. This will insure the sensor wire locks into the harness connector. Do not over bend the pin tine or it may break off.
|
