Sundance® Spas and Jacuzzi Spas Flow Switch

Part Numbers: 6560-860, Q-12DS-C2

Details:

• Flow Switch with Transparent Tee 3/4 inch barb with s 3/8 inch barb off the side. We offer only as complete unit with plastic housing (clear plastic housing is not sold separately)

• 3/4" Barbed. Replaces part number 6560-858

• Manufactured by Harwil

Used On the Following Spa Models:

• 06/1999-2015 Sundance 850/880 Series: Maxxus, Optima, Cameo, Majesta, Altamar, Marin
• 2012-2015 880 Aspen
• 2001-2015 850/880 Capri 1 pump
• Jacuzzi J-300 LCD Series Models, 2002+ (with box end connectors)
• If you have 2002+ LED J-300 use the 2560-040 (Curled Finger Connectors)
• Note: Flow Switch now comes molded with a 3/32" hole opening. Prior to Feb. 2008 a 3/32" hole had to be drilled for it to be installed on all 2002 to mid 2008 2- and 3-pump Sundance models (except Capri). Plug used but not drilled on 2001+ Capri.

Flow Switch with Transparent Tee. Fits all 6/99-Present 2 Pump/ 3 Pump Systems. and 2001+ 1-Pump Capri Systems. 3/4" Barbed.Replaces 6560-858. A defective flow switch will cause a "Flashing Flo" or even a "Solid Flo" on the Control Panel Icon. "Solid Flo" is the Flo Switch, a "Flashing Flo" could be: Flo Switch, Circulation Pump(clogged or defective), Dirty Filter.
The connectors on the Flow Switch are attached to a pc board connector that is located on the PC Board (usually at the top). There are other wires connected to this plug: Jumper interlock wire,Flow Switch, High Limit and Temp sensor. Remove the pin connector from the board . To remove a sensor or switch wire from the sensor harness connector, insert a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine, allowing the wire to be pulled from the harness connector. Important! When reinstalling the sensor or switch wire back into the sensor harness connector, make sure the pin tine is lifted (approx. 1/32") prior to inserting the wire. This will insure the sensor wire locks into the harness connector. Do not over bend the pin tine or it may break off