google-site-verification: google62e582af54a5aae5.html
www.spapartsfinder.com
Search
Navigation
Accessories
Air Blowers
Circuit Boards
Control Panels
Electrical Components
Filters
Flow Switches and Sensors
Heaters
Jets
Ozone Systems
Pillows
Plumbing Components
Pumps, Motors and Components
Time Clocks
ABOUT SSL CERTIFICATES
Special Sale!
SUNDANCE® SPA SALE GOING ON NOW
å
Join our mailing list!
(Your shopping cart is empty)
Home
>
Flow Switches and Sensors
>
Sundance® Spas Flow and Pressure Switches
>
6560-857 Sundance® Spas Flow Switch, with Transparent Tee Fitting, Q-12DS-C2
Alternative Views:
6560-857 Sundance Spas Flow Switch, with Transparent Tee Fitting, Q-12DS-C2
MSRP $104.24
Sale Price $
93.00
Product Code:
6560-857
Qty:
Description
Applications
Sundance® Spas Flow Switch
Part Numbers: 6560-857, Q-12DS-C2
Details:
Flow Switch with Transparent Tee Fitting
3/4" Barbed
Note: if your flow switch has a barb fitting (3/8") off the bottom of the Tee then you need to order the
6560-860 Flow Switch
Used On the Following Spa Models:
All 1-Pump Sundance® Spas using the 6500-301 or the 6500-310 Heater
Except for 2001+ Capri
Flow Switch with Transparent Tee Fitting. Fits All 6/99 - Present 1 Pump Sundance Systems (Except 2001+ Capri). 3/4" Barbed
A defective flow switch will cause a "Flashing Flo" or even a "Solid Flo" on the Control Panel Icon. "Solid Flo" is the Flo Switch, a "Flashing Flo" could be: Flo Switch, Circulation Pump(clogged or defective), Dirty Filter.
The connectors on the Flow Switch are attached to a pc board connector that is located on the PC Board (usually at the top). There are other wires connected to this plug: Jumper interlock wire,Flow Switch, High Limit and Temp sensor. Remove the pin connector from the board . To remove a sensor or switch wire from the sensor harness connector, insert a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine, allowing the wire to be pulled from the harness connector. Important! When reinstalling the sensor or switch wire back into the sensor harness connector, make sure the pin tine is lifted (approx. 1/32" prior to inserting the wire. This will insure the sensor wire locks into the harness connector. Do not over bend the pin tine or it may break off.
Share your knowledge of this product with other customers...
Be the first to write a review
Browse for more products in the same category as this item:
Flow Switches and Sensors
>
Sundance® Spas Flow and Pressure Switches
Spapartsfinder.com
About Us
Shipping And Return Policy
Privacy Policy
Send Us Feedback
Company Info
|
Advertising
|
Product Index
|
Category Index
|
Help
|
Terms of Use
Copyright © Spapartsfinder.com. All Rights Reserved.
Built with
Volusion