Sundance® Spas and Jacuzzi® Spas Advanced Plasma Gap Ozone
The Advanced Plasma Gap ozone replaces the 6473-124 and 6473-125 Ozone used from 2005+. Also replaces all previous 240 Volt Ozones used.
The power cord comes with the J&J plug that Sundance and Jacuzzi started using in 2005. If you wish to use it on earlier models that used the square Molex plug, then you can order the 6000-953 adapter cord or hardwire (take the end off and direct wire) to the system. See Info below on Wire Color Code.

120 Volt Systems: This Unit has the ability to be wired 120 or 240 Volt and can replace any 120 Volt Ozones (6473-123 or 6472-624)that Sundance or Jacuzzi used. You would need to remove the J&J plug on the end of the power cord and hardwire (take the end off and direct wire) to the system.

The Advanced Plasma Gap Ozone:

Is made with an inert metal cell, which means no metals used in the cell so there will be no failure from corrosion. Older systems were susceptable to corrosion due to nitirc acid that is produced.

The new Corona Discharge System uses ceramic technology.

Better technology gives you a lower cost for opertion.
Smaller profile for easier fit in to any size spa. 3.25 inch by 5 inch by 2.25 inch

Ozone output rated at 125 MG

Can also be hardwired if fitting that comes with it does not match up to your connector.

Correspond color code as follows:

Black wire (old unit) to Blue wire (new unit)

White wire (old unit) to Brown wire (new unit)